Hi,
I just got a new 30gb hard drive and i'm running the drive builder software. The wizard stated that it completed successfully. The deck is still using the hard drive, and every now and then this table pops up on the screen show how many spin ups the drive has done, and some seek info? i've never seen this table before and i don't want to uplug the deck to run the software upgrade.

here is some hyperterm output
hdstress.cpp 194 ( 29): Read a button press
hdstress.cpp 194 ( 29): Read a button press
hdstress.cpp 189 ( 29): Poll result=0 on fd=5
Stressing /dev/hda: Spinning down.
hdstress.cpp 189 ( 29): Poll result=0 on fd=5
Stressing /dev/hda: Spinning up.
hdstress.cpp 189 ( 29): Poll result=0 on fd=5
hdstress.cpp 189 ( 29): Poll result=0 on fd=5
Speed checking /dev/hda3
hdstress.cpp 189 ( 29): Poll result=0 on fd=5
Read/write of 8Mb took 3.20 seconds
hdstress.cpp 189 ( 29): Poll result=0 on fd=5
Stressing /dev/hda: Spinning down.
hdstress.cpp 189 ( 29): Poll result=0 on fd=5
Stressing /dev/hda: Spinning up.
hdstress.cpp 189 ( 29): Poll result=0 on fd=5
hdstress.cpp 189 ( 29): Poll result=0 on fd=5
Stressing /dev/hda: Spinning down.
hdstress.cpp 189 ( 29): Poll result=0 on fd=5
Stressing /dev/hda: Spinning up.
hdstress.cpp 189 ( 29): Poll result=0 on fd=5
hdstress.cpp 189 ( 29): Poll result=0 on fd=5
Drive length is 58605120 blocks, seek testing

It's running a stress test. The builder was successful. The only thing you can do now is remove the power.