Finished my EMPEG install in my car, one thing I noticed which I was a little concerned about was after testing the EMPEG in the car, pulling it out I noticed on the unit itself on both sides
near the back end, a small round discolored mark like a burn mark, this is on both opposite sides.
Did a smell test nothing unusual, and the unit works fine, was working on my desk for a week fine. Wondering if anyone else has come across this?, I will post a picture up when I get home from work....

I know all the connections are fine triple checked & I tested them, my original head unit is working fine.

Any help appreciated.

Cheers,
Jaidev

Yea i have the same on mine. Nothing to worry about. I think its just the weld mark for the casing.

RioCar 10GB RGB - can never decide

Don't worry, they're spot welds. If your wiring had caused this, you would definitely have known all about it at the time!

Rob